Saturday, November 2, 2019

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 757

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 757

This DTC can set only when the output is actively being requested by the BCM.

Conditions for Setting the DTC

If the BCM detects a short to ground in the WIPER 1 relay control circuit.

Action Taken When the DTC Sets

The BCM will not activate the output.

Conditions for Clearing the DTC

* The current DTC will become history when the request for the output is removed or when the condition for setting the fault is corrected.

* The history DTC will clear after 50 consecutive ignition cycles without a fault present.

Reference Information

Schematic Reference

Wiper/Washer Schematics (See: Wiper and Washer Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Wiper/Washer System Description and Operation (See: Wiper and Washer Systems/Description and Operation/Wiper/Washer System Description

and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, wiper switch in LOW position. Verify the windshield wipers are cycling at the low speed.

Circuit/System Testing

1. Ignition OFF, disconnect the X5 harness connector at the BCM.

2. Ignition ON, verify that the low speed wipers are not on.

锟斤拷If the low speed wipers are on, test the WIPER 1 relay control circuit terminal 20 for a short to voltage. If the circuit tests normal, replace

the underhood fuse block.

3. Install a 10A fused jumper wire between the WIPER 1 relay control circuit terminal 20 and B+. Verify the low speed wipers are on.

锟斤拷If the low speed wipers are not on, test the relay control circuit for an open/high resistance or short to ground. If the circuit tests normal

replace the underhood fuse block.

4. If all circuits test normal, replace the BCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Underhood Electrical Center or Junction Block Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and

Repair/Removal and Replacement/Underhood Electrical Center or Junction Block Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

No comments:

Post a Comment