Sunday, November 10, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2691

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2691

P2729

The transmission control module detects an internal low voltage electrical malfunction of the clutch pressure control solenoid 5 control circuit for

500 milliseconds.

P2730

The transmission control module detects an internal high voltage electrical malfunction of the clutch pressure control solenoid 5 control circuit for

500 milliseconds

Action Taken When the DTC Sets

* DTC P2728 is a Type B DTC.

* DTCs P2729 and P2730 are Type A DTCs.

* The transmission control module defaults the transmission to a limited shift pattern utilizing 2 forward gears and reverse based on the default

detected.

* The transmission control module commands maximum line pressure.

* The transmission control module freezes transmission adaptive functions.

Conditions for Clearing the DTC

* DTC P2728 is a Type B DTC.

* DTCs P2729 and P2730 are Type A DTCs.

Diagnostic Aids

When attempting to set solenoid electrical DTCs, ensure the TCM is warmed up and the transmission is operated long enough to ensure a 3掳C (5掳F)

increase in TCM temperature parameter. This will place the transmission control module in the optimal conditions to test solenoid electrical DTCs.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. Engine ON, verify the transmission fluid temperature is between 50-80掳C (122-176掳F).

2. Operate the vehicle long enough to verify at least a 3掳C (5掳F) rise in the TCM temperature parameter, then operate the vehicle in Park for 5

seconds.

3. Engine ON, observe the scan tool Clutch PC 5 Sol. CKT Status parameter. The reading should display OK or Indeterminate.

瀚慖f the reading is not within the specified range, replace the Q8 control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly replacement,

setup, and programming.

6L50/6L80/6L90 - Automatic Transmission

No comments:

Post a Comment