Sunday, November 10, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2710

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2710

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC P2797

- Auxiliary Transmission Fluid Pump Performance

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The auxiliary transmission fluid pump (ATFP) system supplies the transmission with hydraulic pressure when the vehicle is operating in the

internal combustion engine (ICE) Autostop hybrid mode. The ATFP system consists of an ATFP control module that operates an electric, 12V 3

phase alternating current (ac), motor-driven pump. Two pulse width modulated (PWM) status circuits connect the ATFP control module to the

hybrid powertrain control module (HPCM). The transmission auxiliary oil pump control circuit delivers the HPCM commanded pump speed to the

ATFP control module. The transmission auxiliary oil pump diagnostic circuit supplies the HPCM with the actual pump speed and also with the

operating status of the ATFP control module. The HPCM monitors these circuits for fault conditions.

The ATFP control module inverts 12V direct current (dc) into 12V, 3 phase ac current to operate the pump motor.

The ATFP control module monitors the status of the ATFP motor/pump as well as its own internal circuitry. The ATFP control module does not

store its own diagnostic status. Current ignition cycle diagnostic status is reported to the HPCM over the transmission auxiliary oil pump diagnostic

circuit. The diagnostic status within the ATFP control module is reset at every ignition-off cycle.

Conditions for Running the DTC

* Ignition voltage is 8-18 volts.

* The auxiliary transmission fluid pump is commanded ON.

Conditions for Setting the DTC

The HPCM observes the difference between actual and commanded ATFP pump speed is greater than 500 RPM for 4 out of 4.125 seconds.

Action Taken When the DTC Sets

* DTC P2797 is a Type B DTC.

* The drive motor generator power inverter control module (PIM) disables the Autostop hybrid mode.

Conditions for Clearing the DTC

DTC P2797 is a Type B DTC.

No comments:

Post a Comment