Sunday, November 10, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2709

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2709

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Transmission General Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Special Tools

J 35616 - GM-Approved Terminal Test Kit

Circuit/System Verification

Note: It may be necessary to drive the vehicle slightly forward to engage 4LO on the transfer case.

Verify the scan tool displays Disabled when you select 4HI and Enabled when you select 4LO.

Circuit/System Testing

1. Remove connector from the transfer case control module. With ignition ON and engine OFF, observe with the scan tool the 4WD Low

parameter.

瀚慖f the scan tool indicates Enabled, test the 4WD Low signal circuit for a short to ground.

2. Using the J 35616 - GM-approved terminal test kit, install a fused jumper between the 4WD low signal circuit and ground at the transfer case

control module connector.

瀚慖f the scan tool 4WD Low parameter indicates Enabled when grounded, replace the transfer case control module.

3. Test the 4WD Low signal circuit for an open.

瀚慒ix the open in the 4WD Low circuit.

4. Replace the ECM.

Component Testing

Verify the 4WD Low parameter on scan tool while cycling the 4WD Low switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.

Control Module References (See: Testing and Inspection/Programming and Relearning)for replacement, setup, and programming

P2797

DTC P2797

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

No comments:

Post a Comment