Tuesday, December 3, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 714

2010 Cadillac Truck Escalade AWD V8-6.2L Page 714

Conditions for Clearing the DTC

A current DTC is cleared at least one transmitter has been programmed to the RCDLR.

Reference Information

Schematic Reference

Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry

Transmitter/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Keyless Entry System Description and Operation (Without Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and

Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (Without Accessory 2 Way Remote)

)Keyless Entry System Description and Operation (With Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and

Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (With Accessory 2 Way Remote))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

J 43241 Keyless Entry Tester

Circuit/System Verification

Attempt to program the keyless entry transmitter, refer to Remote Control Door Lock Transmitter Programming (See: Accessories and Optional

Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry Transmitter/Testing and Inspection). The transmitter should program.

Circuit/System Testing

1. Verify that the transmitter is the correct transmitter for the vehicle.

锟斤拷If not correct, replace the transmitter.

2. Place the transmitter on the test pad of the J 43241 and press each button of the transmitter one at a time. The tester should sound a tone and

illuminate a green light when each button is pressed.

锟斤拷If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter battery and retest with the J 43241.

If the condition continues after battery replacement, replace the transmitter.

3. Attempt to program the transmitter, refer to Remote Control Door Lock Transmitter Programming (See: Accessories and Optional

Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry Transmitter/Testing and Inspection). The transmitter should program.

锟斤拷If the transmitter does not program, test the keyless entry antenna for an open/high resistance. If the circuit tests normal, replace the

RCDLR.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for RCDLR replacement, setup, and programming

B3109

DTC B3109, B3110, B3111, or B3112

No comments:

Post a Comment