Wednesday, December 4, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 782

2010 Cadillac Truck Escalade AWD V8-6.2L Page 782

Circuit/System Description

The windshield washer function is controlled by the body control module (BCM). When the washer switch is pressed, ground is applied through

the switch contacts and the signal circuit to the BCM indicating the wash request. The BCM then applies ground through the control circuit to the

coil side of the WSH Relay energizing the relay. With the relay energized, battery voltage from the WPR fuse is applied through the switch

contacts of the relay, the WSW/PUMP Fuse, and the control circuit to the windshield washer fluid pump.

Conditions for Running the DTC

This DTC can set only when the output is actively being requested by the BCM.

Conditions for Setting the DTC

This DTC sets if the BCM detects a short to voltage in the windshield washer pump relay control circuit.

Action Taken When the DTC Sets

The BCM will not activate the output.

Conditions for Clearing the DTC

* The current DTC will become history when the request for the output is removed or when the condition for setting the fault is corrected.

* The history DTC will clear after 50 consecutive ignition cycles without a fault present.

Reference Information

Schematic Reference

Wiper/Washer Schematics (See: Wiper and Washer Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Wiper/Washer System Description and Operation (See: Wiper and Washer Systems/Description and Operation/Wiper/Washer System Description

and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Operate the washers using the WASH switch. Verify the washer pump activates.

Circuit/System Testing

1. Ignition OFF, disconnect the X4 harness connector at the BCM.

2. Ignition ON, verify the windshield washer pump is not on.

锟斤拷If the windshield washer pump is on, test the windshield washer pump relay control circuit terminal 15 for a short to ground. If the circuit

tests normal replace the underhood fuse block.

3. Install a 10A fused jumper wire between the relay control circuit terminal 15 and ground. Verify the windshield washer pump is on.

锟斤拷If the windshield washer pump is not on, test the relay control circuit for a short to voltage or an open/high resistance. If the circuit tests

normal replace the underhood fuse block.

4. If all circuits test normal, replace the BCM.

No comments:

Post a Comment