Sunday, December 22, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 2515

end of a pencil.

锟斤拷If any TFP switch parameter does not change states, replace the Q8 control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control solenoid valve assembly replacement. Refer to Control Module References (See: Testing and Inspection/Programming and

Relearning) for replacement, setup, and programming.

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

P0990

DTC P0989 or P0990

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0989

- Transmission Fluid Pressure (TFP) Switch 5 Circuit Low Voltage

DTC P0990

- Transmission Fluid Pressure (TFP) Switch 5 Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The transmission fluid pressure (TFP) switch 5 is part of the control solenoid valve assembly which has no serviceable parts. The TCM supplies a

signal circuit to the TFP switch 5. The TFP switch 5 has an internal case ground. TFP switch 5 is normally closed or LOW. When oil pressure is

present at the TFP switch 5, the switch is open or HIGH. The normally high pressure control (PC) solenoid 3 controls pressure to the CBR1/4-5-6

clutch regular valve. The TCM monitors the TFP switch 5 signal circuit to determine the position of the CBR1/4-5-6 clutch regulator valve. When

the 4-5-6 clutch is commanded OFF, pressure is present on the TFP switch 5. When the 4-5-6 clutch is commanded ON, the CBR1/4-5-6 clutch

regulator valve moves and pressure to the TFP switch 5 is exhausted through the CBR1/4-5-6 clutch regulator valve.

Conditions for Running the DTC

P0989 or P0990

* DTCs P0711, P0712, P0713, P0973, P0974, P0976, P0977, P1915, or P182E are not set.

No comments:

Post a Comment