Tuesday, December 3, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 722

2010 Cadillac Truck Escalade AWD V8-6.2L Page 722

Power Door Locks Description and Operation (See: Body and Frame/Locks/Power Locks/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Command the Lock Rear Doors and Unlock Rear Doors with a scan tool, the rear doors should perform the LOCK and UNLOCK function.

Circuit/System Testing

1. Ignition OFF, disconnect the X3 harness connector at the I/P fuse block.

2. Connect a test lamp between the control circuit terminal A2 and ground.

3. Ignition ON, command the Lock Rear Doors with a scan tool. The test lamp should briefly illuminate during the LOCK command.

锟斤拷If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the BCM.

锟斤拷If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.

4. Connect a test lamp between the control circuit terminal A3 and B+.

5. Command the Unlock Rear Doors with a scan tool. The test lamp should briefly illuminate during the UNLOCK command.

锟斤拷If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the BCM.

锟斤拷If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.

6. If all circuits test normal, replace the I/P fuse block.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Instrument Panel Electrical Center or Junction Block Replacement - Left Side (See: Maintenance/Fuses and Circuit Breakers/Fuse

Block/Service and Repair/Removal and Replacement/Instrument Panel Electrical Center or Junction Block Replacement - Left Side)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming

B3135

DTC B3130 or B3135

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B3130 00

- All Door Unlock Circuit

DTC B3135 00

- All Door Lock Circuit

No comments:

Post a Comment