Wednesday, December 4, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 765

2010 Cadillac Truck Escalade AWD V8-6.2L Page 765

* Steering Wheel Secondary/Configurable Control Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical

Diagrams/Steering Wheel Secondary/Configurable Control Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Cruise Control Description and Operation (See: Cruise Control/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of

the cruise control switches. The parameter should toggle between ON, OFF, Resume, Set, and Cancel as the applicable switch is pressed.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.

2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.

锟斤拷If less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the

BCM.

3. Test for B+ between the B+ circuit terminal 1 and the signal circuit terminal 3.

锟斤拷If less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the BCM.

4. Ignition OFF, disconnect the X1 harness connector at the BCM.

5. Test for infinite resistance between the signal circuit terminal 3 and ground.

锟斤拷If less than the specified value, test the signal circuit for a short to ground.

6. If all circuits test normal, test or replace the steering wheel control switch-left.

Component Testing

1. Disconnect the harness connector at the steering wheel controls switch - left.

2. Cruise control switch ON, measure the resistance between terminal 1 and terminal 3 while individually activation and holding each cruise

control function switch and compare the resistance reading to the values in the table below.

锟斤拷If not within the specified resistance range, replace the steering wheel controls switch - left.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

No comments:

Post a Comment