Wednesday, December 4, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 745

2010 Cadillac Truck Escalade AWD V8-6.2L Page 745

The BCM clears this code from current when the fault is removed from the system.

Reference Information

Schematic Reference

Interior Lights Dimming Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Interior Lights Dimming

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Interior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Interior Lighting Systems Description

and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, headlamp switch to HEAD, vary the interior lamp dimming switch from dim to full bright. The I/P lamps should dim and then become

full bright.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the headlamp and panel dimmer switch.

2. Ignition OFF, verify that a test lamp illuminates between the ground circuit terminal 8 and B+.

锟斤拷If the test lamp does not illuminate, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool Dimming Control Signal parameter is less than 0.1 V.

锟斤拷If greater than the specified range, test the signal circuit terminal 13 for a short to voltage. If the circuit tests normal, replace the BCM.

4. Ignition ON, test for 12 V between the I/P dimming voltage reference circuit terminal 15 and ground.

锟斤拷If less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the BCM.

5. Install a 3 A fused jumper wire between the signal circuit terminal 13 and the voltage reference circuit terminal 15. Verify the scan tool BCM

Dimming Control Signal parameter is greater than 2.6 V.

锟斤拷If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the BCM.

6. If all circuits test normal, test or replace the headlamp switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Headlamp Switch Replacement (Cadillac) (See: Lighting and Horns/Headlamp/Headlamp Switch/Service and Repair/Headlamp Switch

Replacement (Cadillac))Headlamp Switch Replacement (Except Cadillac) (See: Lighting and Horns/Headlamp/Headlamp Switch/Service

and Repair/Headlamp Switch Replacement (Except Cadillac))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

No comments:

Post a Comment