Wednesday, December 4, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 774

2010 Cadillac Truck Escalade AWD V8-6.2L Page 774

The BCM detects a fault in the right rear window up circuit.

B3823 00

The BCM detects a fault in the right rear window down circuit.

Action Taken When the DTC Sets

The left or right rear power window will be inoperative from the driver master control.

Conditions for Clearing the DTC

* The DTC will be current for as long as the fault is present.

* When the fault is no longer present, the DTC will be a history DTC.

* A history DTC will clear after 50 ignition cycles.

Reference Information

Schematic Reference

Moveable Window Schematics (See: Windows and Glass/Windows/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Power Windows Description and Operation (See: Windows and Glass/Windows/Description and Operation/Power Windows Description and

Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, command the appropriate rear door window UP and DOWN by using the window switch on the driver master control. The rear door

window should perform UP and DOWN function.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the appropriate rear window switch.

2. Ignition ON, test for greater than 9 volts between the signal circuit terminal A and ground while commanding the rear window UP by using

the window switch on the driver master control.

锟斤拷If less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

BCM.

3. Test for greater than 9 volts between the signal circuit terminal C and ground while commanding the rear window DOWN by using the

window switch on the driver master control.

锟斤拷If less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

BCM.

4. If all circuits test normal, replace the rear window switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Rear Side Door Window Switch Replacement (See: Windows and Glass/Windows/Service and Repair/Rear Side Door Window Switch

No comments:

Post a Comment