Sunday, December 22, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 2513

DTC P0990

- Transmission Fluid Pressure (TFP) Switch 5 Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The transmission fluid pressure (TFP) switch 5 is part of the control solenoid valve assembly which has no serviceable parts. The TCM supplies a

signal circuit to the TFP switch 5. The TFP switch 5 has an internal case ground. TFP switch 5 is normally closed or LOW. When oil pressure is

present at the TFP switch 5, the switch is open or HIGH. The normally high pressure control (PC) solenoid 3 controls pressure to the CBR1/4-5-6

clutch regular valve. The TCM monitors the TFP switch 5 signal circuit to determine the position of the CBR1/4-5-6 clutch regulator valve. When

the 4-5-6 clutch is commanded OFF, pressure is present on the TFP switch 5. When the 4-5-6 clutch is commanded ON, the CBR1/4-5-6 clutch

regulator valve moves and pressure to the TFP switch 5 is exhausted through the CBR1/4-5-6 clutch regulator valve.

Conditions for Running the DTC

P0989 or P0990

* DTCs P0711, P0712, P0713, P0973, P0974, P0976, P0977, P1915, or P182E are not set.

* Ignition voltage is 8.6 volts or greater.

* The transmission fluid temperature (TFT) is 0-120锟斤拷C (32-248锟斤拷F).

* Engine speed is 500 RPM or greater for 5 seconds.

Conditions for Setting the DTC

P0989

The TCM detects that the TFP switch 5 signal voltage remains LOW after the 4-5-6 clutch transitions from a HIGH pressure state to a LOW

pressure state. The TCM counts each incident. The DTC sets when 15 counts are accumulated.

P0990

The TCM detects that the TFP switch 5 signal voltage remains HIGH after the 4-5-6 clutch transitions from a LOW pressure state to a HIGH

pressure state. The TCM counts each incident. The DTC sets when 18 counts are accumulated.

Action Taken When the DTC Sets

* DTCs P0989 and P0990 are Type C DTCs.

* The TCM freezes transmission adaptive functions.

Conditions for Clearing the DTC

DTCs P0989 and P0990 are Type C DTCs.

Diagnostic Aids

A TFP switch may malfunction due to normal debris in the transmission fluid causing a TFP Switch DTC to intermittently set. This type of

condition should not be immediately noticeable to a customer, as the switch outputs are used for shift adaptive pressure and do not cause

transmission symptoms unless the switch malfunctions continuously for an extended period of time.

No comments:

Post a Comment