Wednesday, December 4, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 801

2010 Cadillac Truck Escalade AWD V8-6.2L Page 801

Procedures/Connector Repairs/Connector Repairs) Connector Repairs

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections) Testing for Intermittent

Conditions and Poor Connections

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs) Wiring Repairs

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) Control Module References for scan tool information

Circuit/System Verification

Ignition ON, observe the scan tool A/C Evaporator Temperature Sensor parameter. The reading should be between -39锟斤拷F (-35锟斤拷C) and 208锟斤拷F (98锟斤拷C)

and change with evaporator air temperature changes.

Circuit/System Testing

Important: If the evaporator air temperature sensor has an out of range condition caused by a short to voltage, short to ground, or an

open/high resistance, the scan tool will display the same value: 11锟斤拷C (51锟斤拷F).

1. Ignition OFF, disconnect the harness connector at the evaporator air temperature sensor.

2. Ignition OFF, test for less than 10 ohms between the low reference circuit terminal 2 and ground.

锟斤拷If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the HVAC

control module.

3. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal 1 and low reference circuit terminal 2.

锟斤拷If less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

HVAC control module.

锟斤拷If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the HVAC control

module.

4. If all circuits test normal, test or replace the evaporator air temperature sensor.

Component Testing

1. Test the evaporator air temperature sensor by varying the sensor temperature while monitoring the sensor resistance.

2. Compare the readings with the Sensor Resistance Table (See: Heating and Air Conditioning/Specifications/Electrical Specifications) Sensor

Resistance Table and verify that the resistance is within 5 percent of the specification.

锟斤拷If not within the specified range, replace the sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) Diagnostic Repair Verification after completing the diagnostic procedure.

* Air Conditioning Refrigerant Temperature Sensor Replacement (See: Heating and Air Conditioning/Refrigerant Temperature

Sensor/Service and Repair/HVAC - Automatic) Evaporator Air Temperature Sensor Replacement

* Control Module References (See: Testing and Inspection/Programming and Relearning) Control Module References for HVAC control

module replacement, setup, and programming

HVAC - Manual

DTC B3933

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment