Wednesday, December 4, 2019

2010 Cadillac Truck Escalade AWD V8-6.2L Page 754

2010 Cadillac Truck Escalade AWD V8-6.2L Page 754

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, observe the scan tool BCM SWC Bank 1 Status parameter. The reading should be idle and change between SW1-SW7 when pushing

the appropriate switch.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.

2. Ignition ON, test for B+ between the voltage reference circuit terminal 3 and ground.

锟斤拷If less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the BCM.

3. Test for B+ between the voltage reference circuit terminal 3 and the signal circuit terminal 4.

锟斤拷If less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the BCM.

4. Ignition OFF, disconnect the X1 harness connector at the BCM.

5. Test for infinite resistance between the signal circuit terminal 4 and ground.

锟斤拷If less than the specified value, test the signal circuit for a short to ground.

6. If all circuits test normal, test or replace the right steering wheel control switch.

Component Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.

2. Test the resistance between the voltage reference terminal 3 and the signal terminal 4 while depressing the appropriate steering wheel

controls switch listed below.

锟斤拷If not the specified range, replace the steering wheel switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Steering Wheel Control Switch Assembly Replacement (See: Accessories and Optional Equipment/Sensors and Switches - Accessories and

Optional Equipment/Steering Mounted Controls Assembly/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B3631

DTC B3631

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment